Sunday, 22 March 2015

Rapid prototyping and 3dprinting with two colours

I just purchased a dual extruder 3dprinter so I was wondering what wonderful creations I would be able to dream up. After toying with a combination of #Meshlab, #Meshmixer, #Thingiverse and #replicatorg I finally came up with these two marvellous creations. #marvell


Just wanted to share these #beautifuldesign with you all
#ukproductdesign #productdesignuk #madeinuk#madeinbritain #productdesign #industrialdesign#lightingdesign #cellulardesign #magicmodel


Posted by at
3D Printing, figureprint, wow, zbrush, modelmaking , , , , , , , , , ,

2 comments:

  1. Vitalii Anufriiev29 September 2015 at 07:55

    My friend has a 3D printer, but he has no clue what to make on it. This article inspired to some creative Ideas to do. I'm a writer and web designer at the same time so everybody may suggestions what he should do - and after that Im going to make a new post at Writers Per Hour.

    ReplyDelete
  2. Unknown10 November 2016 at 02:22

    Good luck with your writing and printing James

    ReplyDelete

Subscribe to: Post Comments (Atom)