Thursday, 30 October 2014


High res versus low res
Magicmodel 3dprinters are capable of producing parts in 2 resolutions. If you require a quick turnaround and
your part is quite big ie 150mm x 150mm x 150mm say then you ought to opt for the low resolution at 0.25mm per
layer. This is pretty much the default for most fdm based machines as it gives a good balance between quality
and speed. Both resolutions allow for 0% – 100% infill which can also help speed things up whilst preserving
the strength of your part or model.

No comments:

Post a Comment